Installation Guide: Tilt Cage Offsets for Mōvi Pro

Installation Guide: Tilt Cage Offsets for Mōvi Pro

Thank you for purchasing Ignite Digi's Tilt Cage Offsets for Mōvi Pro!

The tools required for installation are: 

• 7.5mm Allen key

• 2mm Allen key

• 2.5mm Straight Allen Key

Step 1: With the 7.5mm Allen key, remove the 4 socket head cap screws from the base of the tilt stage.

Step 2: Disconnect the IMU Cable, ease the connector out with a small 􀀊at screwdriver

Step 3: Disconnect the bullet connectors for power.

Step 4: Slide the cable partially out of the side arm to give enough room to work. 

Step 5: With the straight (Not Ball) 2.5mm Allen key, remove the four socket head cap screws holding the existing tilt bracket in place on both the bearing ana motor side.

Step 6: With the 2.5mm Allen key, install the tilt offsets with the supplied M3x12 Sf-iCS on both sides of the Mo VI Pro.

Step 6.5: The bracket for the motor side has the M3 screw sticking out to prevent over rotation of the tilt stage.

Step 7: Reinstall the tilt cage and carefully reconnect the IMU Cable and power wires, and close the cover by reinstalling the original screws. 

Step 8: Install your camera package, balance the MoVI Pro, and happy shooting!